A leaking pipe is not always obvious. Water can travel through floors and walls before appearing as a damp patch in the wrong room entirely. Murphy's Plumbing uses thermal imaging cameras to find the source without opening up walls unnecessarily.
Burst pipes are treated as emergencies. If water is actively flowing, call the 24/7 line on 046 123 789. For slower leaks and damp investigations, a standard appointment works fine.
Conor carries copper, plastic, and push-fit fittings on the van. Most pipe repairs are completed in a single visit, with the wall or floor reinstated the same day where possible.
How it works
- 1
Isolate the water
For active bursts, turn off the water at the stopcock (usually under the kitchen sink or near the water meter). Then call us. Conor will advise whether to call as an emergency or book a standard appointment.
- 2
Leak investigation
Thermal imaging is used to trace the leak without unnecessary damage. Conor identifies the fault and explains the repair needed before starting work.
- 3
Repair and test
The pipe is repaired or replaced and the system is pressure-tested. You get confirmation the repair is holding before Conor leaves the site.
Frequently asked questions
- How does thermal camera leak detection work?
- A thermal imaging camera shows temperature differences in walls and floors. A leaking pipe causes a cooler (or warmer, depending on the pipe type) patch that is clearly visible on the thermal image. This allows Conor to mark exactly where to investigate without guesswork.
- My walls are damp but I cannot find the source. Can you help?
- Yes. Damp investigations are a common call for Murphy's Plumbing. Thermal imaging combined with a moisture meter usually pinpoints the source within 30 minutes. The cause is often a slow drip behind tiles or under a floor rather than a roof or drainage problem.
- Will the wall or floor need to be opened up?
- In most cases, yes, to access the pipe for repair. The difference with thermal imaging is that only the smallest necessary area is opened, rather than opening a full wall to search. Reinstatement is advised but not always covered under the plumbing price.
- What is the call-out rate for a pipe repair?
- Standard call-outs start at €95 during weekday hours. This covers the visit, leak investigation, and a quote for the repair. Out-of-hours emergency call-outs are also €95 flat rate.
- My pipes are making a banging noise. Is that serious?
- A banging pipe (water hammer) is usually caused by a faulty check valve or a loose fitting inside the wall. It is rarely dangerous but it is worth fixing before it causes joint failure. Murphy's Plumbing diagnoses and resolves water hammer as a standard call-out.